I have to be honest with you. I wasn't going to share this one. It was just too good. What if I let this cat out of the bag and everybody and their grandmother started cashing in on it? What then? But then I figured, what the hell? It's not like I do a lot of work these days and spend a lot of time on this one. Sure, I intend to dabble a bit, but full time? No way in hell. I'd much rather be playing video games and Magic the Gathering. So for the rest of us working stiffs, this one's for you.

The water bill arrives and the consumption is higher than normal. In looking at the bill you realize it's winter time, your water consumption is down, but the bill says it is up as if its summer when your water consumption is higher. Then it hits you bathtub a water leak! At some point almost all homeowners run into this problem.

Turn off the water to the water line repair heater or if the valve is not working turn off the water to the house. If the valve is not working it will need to be replaced. In a future article we will discuss how to replace your valve.
 

If you bought the same unit it should line right up, if you were unable, you will need to remove or add length to the existing piping. This may require you to splice together copper with plastic, don't let this scare you the hardware store will have all of the necessary parts.

Working on the gas lines is also a complex job that only a licensed plumber can handle because it is very dangerous. Small leaks can't always be detected by odor alone, but a licensed professional has the proper equipment that's needed to ensure that you don't have any leaks in the line.

If the area around the fan isn't clean and dry, or if dust or any sort of growth has accumulated on the blades or inside the exhaust duct, it may be a warning sign of excess moisture build-up. Clean the water line repair fan and area well. Then double- check that the fan is operating properly.

For a newly installed icemaker, you will need up to 24 hours to let the machine function and cool down. A newly installed icemaker may not work until the ice mold temperature has dropped to about 15F - 16F degrees. If you have just added a water line to the refrigerator, it may take up to about an hour and a half for the machine to start working. Also, a newly installed water line may have air in the line. It can sometimes take a few ice making cycles to clear the line of air.

Sometimes there can be complications of broken toilet flanges, closet bolts or rotted sub-flooring. If you find any of that in your situation, it will need to be repaired before reinstalling the toilet.